Governor Model: WESGOV and WESGOVD
AutoCorrection Properties
Following checks and corrections are applied during Validation and AutoCorrection.
- If 0.0 < Ti < Mult*TimeStep then Ti = Mult*TimeStep
- If 0.0 < T1 < 0.5*Mult*TimeStep then T1 = 0, ElseIf 0.5*Mult*TimeStep < T1 < Mult*TimeStep then T1 = Mult*TimeStep
- If 0.0 < T2 < 0.5*Mult*TimeStep then T2 = 0, ElseIf 0.5*Mult*TimeStep < T2 < Mult*TimeStep then T2 = Mult*TimeStep
Mult represents the user-specified value Minimum time constant size as multiple of time step option on the Validation page of the Transient Stability Dialog
TimeStep represents the integration time step being used as described on TimeStep
Model Equations and/or Block Diagrams
Parameters for WESGOV:
| DeltaTC | Delta t sample for controls, sec |
| DeltaTP | Delta t sample for PE, sec |
| Droop | Droop |
| Kp | Proportional gain, pu |
| Ti | Integrator Time constant, sec |
| T1 | Pmech time constant 1, sec |
| T2 | Pmech time constant 2, sec |
| Alim | Maximum change is limited by this value between sampling times |
| Tpe | Pelec time constant, sec |
Parameters for WESGOVD:
| DeltaTC | Delta t sample for controls, sec |
| DeltaTP | Delta t sample for PE, sec |
| Droop | Droop |
| Kp | Proportional gain, pu |
| Ti | Integrator Time constant, sec |
| T1 | Pmech time constant 1, sec |
| T2 | Pmech time constant 2, sec |
| Alim | Maximum change is limited by this value between sampling times |
| Tpe | Pelec time constant, sec |
| dbH | Deadband High (pu) |
| dbL | Deadband Low (pu) |
| Trate | Turbine rating, MW |